How To Overcome The Cranky Canon Cartridge

Hm ..., It's a real experience. The last two days I was a little seized by the printer, more focused cases Canon Printer Cartridges (all types) . Printer does not crash, it's just that little cartridge cranky not want to do a good job. Printer output is far from perfect, the color cartridge just appear one color, which color is the color cyan magenta yellow and it just will not come out. I try Deep Cleaning up more than 10 times is not too fruitful results. 
 

Capitalized reckless, decision finally fell to his prying cartridge (Wuuuihh ... his male ego out, hehehe). An excessive courage because as a beginner that is not supported by adequate equipment and knowledge, secured greater consequences. 50-50 chance of success. But, after doing stages with extreme caution turned out to not only succeed but also new knowledge from the experience of the last two days.

Sure, on some pages I   visit have some variations but essentially the same. And certainly this is the first time I was a little reckless in applying it to cure all Canon Printer Cartridges.

So, the following tips and tricks in repairing Canon Printer Cartridges are problematic:

1. The initial step try to have the balls were quite large, since the slightest wrongdoing ngeruk guaranteed hefty wallet to buy a new cartridge.
2. Provide plates, instrument bail or glass / cans are made of plastic and glue
3. Prepare warm water (Loh? Kok all of the tools to prepare a dish? Relax, this is part of a rudimentary tool .. ok ... seriously this loh)
4. Take it from the printer cartridge and open the top of the cartridge, poked it with a knife / small screwdriver.
5. Take all the cork is in the cartridge, place it in a clean
6. Pour warm water into the dish, then soak the Head Cartridge (where the ink discharge) but not soaked it all, because his name is always prone electronics when meeting water. Leave on for 10-15 minutes
7. Cork that has been taken was flush with hot water until completely clean. After it dried up completely no water even merely the seepage water, which surely must be completely dry. (Can be dried in the sun in the sun)
8. Cartridges that have been raised soak then wipe with a paper towel on the inside of the cartridge until it is completely clean, no ink imprint.
9. Cartridge Head Clean also part of her, but remember not too hard when sanities, just a little scratched her element then Cartridges can be damaged / can not be used anymore
10. Once the cartridge is really clean, and the cork has dried up completely, then reinsert the cork as before. Then close the lid Cartridge her with glue. Allow the glue to dry.
11. Next, insert the ink, if Cartridge color, size Cyan, Magenta, and Yellow must be the same number. Just a little different, then the printer prints the results will not be perfect. (Fill ink not too little, or even excessive)
12. The last step, enter Cartridge into the printer, do Deep Cleaning (Cleaning not only) to perfect result.

Analisis Cartridge Printer Canon:

1. If the cartridge is in place on smooth tissue, the ink comes out perfectly but could not do the typing and the results are still striped print, shadowed, meaning Cartridge has been replace with a new request
2. If the cartridge is placed in tissue but can not remove the ink or ink discharge even very much, it means there is a dead end (clogged) on Head Cartridge, could still be helped.
3. If the printout yellow to green and so on, it means that the ink in one color is more / less than the other colors. Should do the trick above.

Tips on maintaining the printer to remain durable:

• The printer must live at least one time within 24 hours to prevent clogged / blocked, ink froze in the Cartridge
• If you do print black only, the printer must rest for a minimum of 1 minute if we already produce print as much as every 25 sheets of paper, after 1 minute can be continued again
• If you do a color print, minimal rest for 1 minute each printer after generating as many as 4 sheets of printed paper.

Read More

How To Reset Canon iP2770 Form ServiceTool_V1074

What's up buddy all? May the best buddy in the state and no one any less, no mate never suffered as I did, when going to print data suddenly my printer canon iP2770 blink resume and a power indicator light indicates an error and could not doing anything, can not even catridnya move at all, some say it's time has adiklah and so on ... If sbat weve also experiencing the same thing maybe this article can help, good luck ...

How to Reset Canon iP2770 Error 5B00:

• Printer alive

• Press and hold the RESUME button then press and hold the POWER button 5 times each and then release both buttons simultaneously (Led will blink briefly then will flash GREEN)

• The computer will detect the new device, cancel it .....

• This shows the iP2770 printer is in a state of SERVICE MODE and ready to be reset.

• Run iP2770 Resetter v1074 it: File Exctract iP2770 Resetter . if you do not have 

          ==> Download Here <==  

• Prepare some paper in the printer (to print on a mini reset process).

• Run the program iP2770 Resetter

•  Click "PLAY", then the printer will proceed, then iP2770 will print one page with the words "D = 000.0"

• Click "EEPROM Clear".

• Then click "EEPROM", and the printer will print the results iP2770 Resetter

• Turn off the printer by pressing the POWER button and turn it back on, hopefully useful .... I Love Your Comment ...

Read More

HOW TO FIX CANON PRINTER CARTRIDGES

Problems often occur in the printer is the cartridge, the problems such as the cartridge isdry, dead ends, striped etc..

Not just a problem that occurs in the printer cartridge but this is generally common. Nowwe will try to discuss the problem on a dry or clogged cartridges that do not come outautomatically.

I only give it 2 ways to fix a clogged cartridge which has been successfully proven results, so check out the tutorial to fix canon printer cartridges following:

Cartridge Soaking In Hot Water

     1. Remove the cartridge from the printer
     2. Prepare a place to soak the cartridge, can be put on a plate that has been unused
         Fill the plate with hot water + cold water, do not expect too hot and too cold
     3. Soak the cartridge in warm water for approximately 15-20 minutes
     4. If it is soaked, replace the cartridge back into the printer
     5. Printer print test, if the results are good it works

Wash Foam Cartridge

     1. Open the cover of the cartridge using a cutter
     2. Remove the foam from the cartridge
     3. Busah washing with water until it is completely clean
     4. Drying foam until completely dry
     5. Replace the foam into the cartridge
     6. Use glue to glue the cover korean cartridge
     7. Attach the cartridge and do a test print
     Finish

Hopefully fix the tutorial discussion of canon printer cartridges can resolve your problem. 

Thank you

Read More

HOW TO FIX PRINTER PAPER CAN NOT PULL

The problem of the printer can not pull paper is a simple problem, and to find out the cause of the printer can not pull paper, quite difficult because the location is in the rollerinside the printer, therefore it takes action to open the printer casing to issue or cause the printer can not pull paper can found. 

Today Computer Technician Denpasar fix two printers with the same damage indicatorthat printer can not pull paper. The first is the Epson printer, but I forgot the type, clear the printer can be used for scanners and photo copy. The second printer is a Canon Pixma MP287 printer. 

Damage as told above that the printer can not pull paper can be handled in the following manner. 

1 Regional Roller Cleaning Paper 
To clean the area around the roller paper is not easy, by the necessary demolition kareacasing / cover of the printer to be able to more freely to clean the roller area. Consider thepossibility of dust and other hard objects that accidentally get into the paper roller area. 
Noteworthy is the ceiling of the house in which he placed the printer. So what to do with the ceiling of the house printer. There is pal, where the ceiling has begun to decay, most likely there is dirt falling from the ceiling of the house and into the area of ​​the paper roller.In addition to the ceiling, also check other small objects that can fit into areas such asroller, paper clips, pieces of paper and other objects that would be near the printer. 
If there is a foreign object found in a paper roller area, immediately remove and clean thedust from the roller paper also. If it does not find foreign objects in paper roller area, thenkeruskan may occur in the circuit roller paper, such as roller serrations are worn and others. 

2 Changing the Paper Roller 
Besides simply by cleaning the roller first paper on the way over, my friend can alsodisassemble components and roller paper check, whether there is a paper roller serrationsare broken or worn. If worn or broken, please replace the paper roller new or used but stillfit for use. 
Thus two ways to fix the printer can not pull paper when pencetakkan. Hopefully this article useful for users deskjet printer.

Read More