How To Overcome The Cranky Canon Cartridge

Hm ..., It's a real experience. The last two days I was a little seized by the printer, more focused cases Canon Printer Cartridges (all types) . Printer does not crash, it's just that little cartridge cranky not want to do a good job. Printer output is far from perfect, the color cartridge just appear one color, which color is the color cyan magenta yellow and it just will not come out. I try Deep Cleaning up more than 10 times is not too fruitful results. 
 

Capitalized reckless, decision finally fell to his prying cartridge (Wuuuihh ... his male ego out, hehehe). An excessive courage because as a beginner that is not supported by adequate equipment and knowledge, secured greater consequences. 50-50 chance of success. But, after doing stages with extreme caution turned out to not only succeed but also new knowledge from the experience of the last two days.

Sure, on some pages I   visit have some variations but essentially the same. And certainly this is the first time I was a little reckless in applying it to cure all Canon Printer Cartridges.

So, the following tips and tricks in repairing Canon Printer Cartridges are problematic:

1. The initial step try to have the balls were quite large, since the slightest wrongdoing ngeruk guaranteed hefty wallet to buy a new cartridge.
2. Provide plates, instrument bail or glass / cans are made of plastic and glue
3. Prepare warm water (Loh? Kok all of the tools to prepare a dish? Relax, this is part of a rudimentary tool .. ok ... seriously this loh)
4. Take it from the printer cartridge and open the top of the cartridge, poked it with a knife / small screwdriver.
5. Take all the cork is in the cartridge, place it in a clean
6. Pour warm water into the dish, then soak the Head Cartridge (where the ink discharge) but not soaked it all, because his name is always prone electronics when meeting water. Leave on for 10-15 minutes
7. Cork that has been taken was flush with hot water until completely clean. After it dried up completely no water even merely the seepage water, which surely must be completely dry. (Can be dried in the sun in the sun)
8. Cartridges that have been raised soak then wipe with a paper towel on the inside of the cartridge until it is completely clean, no ink imprint.
9. Cartridge Head Clean also part of her, but remember not too hard when sanities, just a little scratched her element then Cartridges can be damaged / can not be used anymore
10. Once the cartridge is really clean, and the cork has dried up completely, then reinsert the cork as before. Then close the lid Cartridge her with glue. Allow the glue to dry.
11. Next, insert the ink, if Cartridge color, size Cyan, Magenta, and Yellow must be the same number. Just a little different, then the printer prints the results will not be perfect. (Fill ink not too little, or even excessive)
12. The last step, enter Cartridge into the printer, do Deep Cleaning (Cleaning not only) to perfect result.

Analisis Cartridge Printer Canon:

1. If the cartridge is in place on smooth tissue, the ink comes out perfectly but could not do the typing and the results are still striped print, shadowed, meaning Cartridge has been replace with a new request
2. If the cartridge is placed in tissue but can not remove the ink or ink discharge even very much, it means there is a dead end (clogged) on Head Cartridge, could still be helped.
3. If the printout yellow to green and so on, it means that the ink in one color is more / less than the other colors. Should do the trick above.

Tips on maintaining the printer to remain durable:

• The printer must live at least one time within 24 hours to prevent clogged / blocked, ink froze in the Cartridge
• If you do print black only, the printer must rest for a minimum of 1 minute if we already produce print as much as every 25 sheets of paper, after 1 minute can be continued again
• If you do a color print, minimal rest for 1 minute each printer after generating as many as 4 sheets of printed paper.